Adding a Hanging Sleeve

from Vintage Quilts Fall 2000 Issue

Download Instructions:  Click here for a .pdf of these instructions. (Problems downloading our .pdf? Click here for troubleshooting tips.)

 

 

1. Cut a 10˝-wide strip of washed muslin or cotton fabric, making it 1˝ shorter than top edge of quilt.

2. Turn under and press 1/2˝ at each short end, then turn and press again (Diagram I). Stitch in place.

 

Adding a Hanging Sleeve to a Quilt


3.
With wrong sides together, stitch long edges together 1/4˝ from raw edges (Diagram II).

 

 

Adding a Hanging Sleeve to a Quilt

 

Press seam open and center it in the tube you've created (Diagram III).

Adding a Hanging Sleeve to a Quilt

 

4. Slipstitch the top edge of the tube to the quilt backing about 1˝ below the inner edge of the binding (Diagram IV).

Adding a Hanging Sleeve to a Quilt


5.
Pin lower edge of sleeve to backing, placing pins 1/4˝ from lower edge. Turn the folded sleeve edge up and slipstitch sleeve to quilt backing, catching only the lower layer of sleeve (Diagram IV). This allows for a little slack so the sleeve takes the weight of hanging, not the quilt. Make sure that the stitches go through only the backing fabric—they should not be visible on the quilt surface.

6.
Slip a rod or strip of lath through sleeve and hang in desired location on nails or decorative brackets.

 

 

Post a comment
To comment on this article you must be logged in. Not a member?

USER COMMENTS

No comments have been posted. Be the first!

Login:

Forgot password?
 
© Creative Crafts Group, LLC. All rights reserved.