Pinning Tips

Download Instructions: Click here to download a .pdf of this lesson. Problems downloading our .pdf? Click here for .pdf troubleshooting tips.


Pinning Units Without Points or Angled Seams

When joining seamed pieces without points or angled seams (Diagram I), butt opposing seams together and pin at an angle to secure. (Diagram II, right handed --- Diagram III, left handed). VERY IMPORTANT: Take at least one stitch past the seam line before pulling the pin. This will insure that the seams do not separate as you sew over them. (If you have pinned as shown in the diagram, there will be room for one or two stitches before having to pull the pin.)

Pinning without points or angled seams

Diagram I

Pining Tips Right Handed

Diagram II

Pining Tips Left Handed

Diagram III

Pinning Units With Matching Points

There are two steps involved when pinning seamed pieces with points that must be matched (Diagram IV). (Make sure seam allowances are opposing before pinning units together.)

Pinning Units with Matching Points

Diagram IV

Step 1.) Referring to Diagram V, insert pin through the wrong side of the fabric where the two seams cross and form a point. Carefully insert the pin through the next unit right side of fabric, at the tip of the point. Push the pin through both units until the head is flush with the fabric.

Step 1 Diagram

Diagram V

Step 2.) Holding the first pin securely, insert another pin on each side of the point, through the seam allowances. (Diagram 6) Notice how pins are turned in opposite directions. This technique helps to keep the points aligned properly. After pinning securely on each side, remove the center pin. Begin sewing at the edge and continue until you are as close as possible to the first pin. Do not sew over the pin. Remove the pin and continue sewing until you are as close to the second pin, without sewing over it, as possible. Remove the pin and continue sewing to the other edge. (Hint: Sew one or two threads above the point when sewing the seam allowance. This will allow room for turning and pressing.)

Step 2 Diagram

Diagram VI

 

Post a comment
To comment on this article you must be logged in. Not a member?

USER COMMENTS

Pinning when seams are the same
You use the same process, just use many more pins on either side of your intersection. - Thanks for asking! - Kathy
pinning when seams are the same
How do you pin for seams that, due to pressing and previous seams, are both facing the same direction?
Matching points pinning
I knew how to pin to match the points but did not know to pin one up and one down. Thank you for the tutorial, you are never to old to learn something new. Judy in Michigan

Login:

Forgot password?
 
© F+W All rights reserved.